112
Adjustment
Room Controller KNX Touch One
• Status: 29.04.2014 • Errors excepted. Subject to technical changes.
Activate: To set the ventilator to Automatic at a set point in time, select
Yes
(default setting).
Deactivate: To switch off the Reset function for this ventilator, select
No
.
Alternatively, the automatic function can be reactivated at a set time following a man-
ual intervention.
Activate: To perform an Automatic Reset after a manual intervention, select
Yes
.
Deactivate: To switch off the Reset function for this ventilator, select
No
(default setting).
Confirm your setting using the
OK
button.
You can set automatic reset times and/or durations.
Settings > Automatic > Automatic Reset
Change automatic settings at the screen, page 67
5.5.
Temperature control
The temperature control must be activated in the ETS first, before it can be used at the
Room Controller KNX Touch One
.
5.5.1.
Setting temperature control using the ETS
The temperature control with a heating and/or cooling is set via the menu item “Tem-
perature control“.
Control in general:
Use control
No • Yes
Type of control
• One-step heating
• Two-step heating
• One-step cooling
• One-step h One-step cooling
• Two-step h One-step cooling
• Two-step h Two-step cooling
Behaviour of the blocking object at value
• 1 = Block control |
0 = Release control
• 0 = Block control |
1 = Release control
Blocking object value
before 1st communication
0 • 1
Send actuating variables
• on change
• on change and periodically
Transmit cycle
(is only transmitted if
“
periodically” is
selected)
5 s … 2 h; 5 min
