111
Adjustment
Room Controller KNX Touch One
• Status: 29.04.2014 • Errors excepted. Subject to technical changes.
Press the button to set the internal temperature to the desired cooling level (for the
night-time re-cooling). The button will only be activated once a night-time re-cooling
temperature has been set.
Use the arrow buttons to change the value as required.
Pre-setting: 16.0 °C .
Confirm your setting using the
OK
button.
Press the button to set the ventilation force. The button will only be activated once a
night-time re-cooling temperature has been set.
Setting ventilation for night-time re-cooling: The ventilator force can be set in 10% in-
crements from 100 to 10% using the arrow buttons. (Default setting: 40%).
Confirm your setting using the
OK
button.
Press the button to set the timed ventilation time. Press
Select
to select the times dur-
ing which ventilation will occur. Activate one or more times on the list.
Confirm your setting using the
OK
button.
To change any of the time periods set in the timer, press
Timer
.
Setting the timer at the screen, page 124
Press the button to set the ventilation force for timed ventilation. The button will only
be activated once a ventilation time for the timed ventilation has been set.
Setting ventilation force for timed ventilation: The ventilator force for timed ventilation
can be set in 10% increments from 100 to 10% using the arrow buttons. (Default setting:
40%).
Confirm your setting using the
OK
button.
Press the button to switch on or off the setting for automatic operation at a set point in
time, or following a manual intervention.
The general Automatic Reset occurs daily at the same time.
NTC interior temp.
only when night-time re-cooling is selected
NTC exhaust steps
only when night-time re-cooling is selected
Timed ventilation
Timed ventilation
Only when a time period for timed ventilation has
been selected
Automatic Reset
