81
Adjustment
Room Controller KNX Touch One
• Status: 29.04.2014 • Errors excepted. Subject to technical changes.
Activate one or more times on the list.
Confirm your setting using the
OK
button.
To change any of the time periods set in the timer, press
Timer
.
Setting the timer at the screen, page 124
The twilight button will only be activated when at least one time-switching period has
been set. Otherwise, the button is greyed out.
Press the button to switch the twilight / night switch on or off. Pressing the
Yes
button
activates twilight switching, and the light is then switched on at night (e.g. below
200 lx). Pre-setting: Yes (twilight switching activated).
Confirm your setting using the
OK
button.
The limit value which identifies twilight/night can be adjusted.
Settings > Automatic > Twilight
Change automatic settings at the screen, page 67
The twilight/night switch has a delay of one minute.
Press the
Dimmer value on
button in order to set the brightness of the light when it
is switched on. Pre-setting: 100%. Adjust the value using the arrow buttons.
Confirm your setting using the
OK
button.
Press the
Dimmer value off
button in order to set the brightness of the light when it
is switched off. Pre-setting: 0%. Adjust the value using the arrow buttons.
Confirm your setting using the
OK
button.
Press the button to switch on or off the setting for automatic operation at a set point in
time, or following a manual intervention.
The general Automatic Reset occurs daily at the same time.
Activate: To set the lights to Automatic at a set point in time, select
Yes
.
Deactivate: To switch off the Reset function for these lights, select
No
(this is the de-
fault setting).
Alternatively, the automatic function can be reactivated at a set time following a man-
ual intervention.
Activate: To perform an Automatic Reset after a manual intervention, select
Yes
.
Twilight
Dimmer value on
Dimmer value off
When a light is used as a dimmer
Automatic Reset
