68
Adjustment
Room Controller KNX Touch One
• Status: 29.04.2014 • Errors excepted. Subject to technical changes.
In order to be able to set the automation functions, at least one relevant drive or a light
must be configured.
Use the arrow buttons to set the value from which the control system should identify
twilight and night. Pre-setting: 10 lx.
Night identification has a delay of one minute.
Confirm your setting using the
OK
button.
You can adjust the delay time for shading actuation. The movement delay prevents the
solar protection system from continuously extending and retracting in the event of rap-
id changes in lighting conditions.
The brightness must remain uninterrupted above the brightness value set for solar
protection for a set delay time (e. g. 1 minute) before the blind will extend. The bright-
ness must remain continuously below the value during the set retraction delay time
(e. g. 12 minutes) before the blind will retract again. This allows passing clouds to be
“
blended out”, while the shading can still react rapidly to the sun.
Use the arrow buttons to set the values for the extension and retraction delays. Pre-
setting: Extension 1 minute, retraction 12 minutes.
Confirm your setting using the
OK
button.
Twilight
Movement delays
