88
Adjustment
Room Controller KNX Touch One
• Status: 29.04.2014 • Errors excepted. Subject to technical changes.
Change general automatic settings using the ETS, page 66
If shading is always used:
If shading is used dependent on brightness:
Use night-time closure
No
• Yes
Use timed closure for
Period 1 - 16
No
• Yes
Use frost protection
No
• Yes
Use wind alarm
No
• Yes
Retract at wind speeds from (in 0.1 m/s)
(only if wind alarm is used)
5...195; 60
for longer than (in sec)
(only if wind alarm is used)
1...5
Retract upon rain
No
• Yes
Perform Automatic Reset
at set time
No
• Yes
after the set waiting period following
manual operation
No
• Yes
Shading
Always
Movement position (in %)
0...100
Shading
Brightness-dependent
From a brightness of (in klx)
1...99; 40
Sun direction
• All sides
• West
• South-West
• South
• South-East
• East
• Angle range
greater than (in °)
(only when the selected
angle range is settable)
0...360; 90
lower than (in °)
(only when the selected
angle range is settable)
0...360; 270
Sun height
• Any height
• Angle range
greater than (in °)
(only when the selected
angle range is settable)
0...90
lower than (in °)
(only when the selected
angle range is settable)
0...90
Movement position (in %)
0...100
Use internal temperature lock shut-off
(only if an interior temperature lock is used)
No
• Yes
Allow shading from (in 0.1 °C)
50...400; 250
