EFI E-36A, Installation And Service Manual, Page: 83 / 129

83 Installation and Service Guide: Color Controller E-36A
Replacing Parts
8 Reassemble the E-36A (see page 83 ).
9 Connect the external cables that you removed from the E-36A.
10 If you replaced the HDD with a new HDD, install system software (see page 96 ).
11 Verify the functionality of the E-36A (see page 83 ).
Restoring and verifying functionality after service
Complete your inspection and service by reassembling and verifying the E-36A.
To reassemble and verify the E-36A
1 Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables in the E-36A make sure that:
•
Covers are securely installed after routing cables.
•
Cables are not looped around internal circuit boards, or components (such as capacitors and resistors).
•
Cable routing does not interfere with the operation of internal components.
•
Cables do not lie on or against any internal heating element.
•
Cables do not interfere with removing or replacing components.
•
Cables do not interfere with opening or closing E-36A panels.
•
Cables are not tangled.
•
Cable slack is secured with tie wraps.
2 Restore the system to the upright position.
3 Replace any panels that you removed earlier, as described in “Opening the E-36A” on page 50.
4 If applicable, reinstall the E-36A in the furniture, as described in “To replace the E-36A in the furniture” on
page 126.
5 If you installed a new hard disk drive, install system software (see page 96 ).
Replacement hard disk drives are not shipped with pre-installed system software.
6 If you replaced the motherboard with a new motherboard, make sure that the new motherboard solves the
problem that you are troubleshooting (see page 107 ), and then transfer options to the new motherboard (see
page 66 ).
7 Make sure to configure the date and time in Setup (see page 74 ).
Do not lift the E-36A without assistance. Follow standard ESD “Precautions” on page 12 when
handling internal components.