EFI E-36A, Installation And Service Manual, Page: 50 / 129

50 Installation and Service Guide: Color Controller E-36A
Replacing Parts
Accessing internal components
This section describes how to shut down and open the E-36A. Always use the following procedures when opening the
E-36A for inspection or service.
Shutting down the system
For accessing the internal components, it is recommended to disable the power synchronization before you shut down
the E-36A. For information about how to shut down the E-36A when power synchronization is OFF, see “To start or
shut down the E-36A when power synchronization is OFF” on page 43.
When shutting down the E-36A, do the following:
•
Remove the power cable from the connector panel before accessing the internal components.
•
If you are cycling power, wait at least 10 seconds before powering back on.
•
If you are unable to shut down the E-36A, power off by pressing the power button on the side of the Fiery
QuickTouch for up to eight seconds.
Opening the E-36A
Before you open the E-36A, it is recommended that you review “Precautions” on page 12 to avoid injury or damage to
the E-36A.
To open the E-36A
1 Shut down the E-36A (see page 42 ).
2 Wait 10 seconds after the E-36A powers off, and then remove all external cables from the back of the E-36A.
3 If applicable, remove the E-36A from the furniture.
5 10-pin power button cable J103 connector on printer
interface board FP HDR connector on motherboard (J11)
6 Fiery QuickTouch power SW/LED
cable Fiery QuickTouch
J102 connector on printer interface board (see Figure 34 )
7 HDD data cable HDD SATA 0 connector on motherboard (J28)
Remember that when the E-36A is powered off, network access to the printer is interrupted.
Always obtain permission from the network administrator before you take the E-36A off the
network.