EFI E-36A, Installation And Service Manual, Page: 67 / 129

67 Installation and Service Guide: Color Controller E-36A
Replacing Parts
5 Select Motherboard Replacement icon.
The screen displays “Reading dongle...”, then displays the number of licenses left to apply to the transfer.
6 Select Yes to confirm the license transfer.
The Fiery QuickTouch displays “Applying...” to indicate the transfer of options and the backup BIOS from the hard
disk drive to the BIOS chip on the replacement motherboard.
Note: If you select No , the process ends and you return to the Functions menu.
7 Reboot the E-36A.
8 Remove the motherboard replacement dongle after the E-36A reaches Idle.
DIMM
DIMM (dual in-line memory module) is held in place by a lever at the end of a DIMM slot. The E-36A motherboard
contains two DIMM slots (DIMM-A0 and DIMM-B0, see Figure 35 on page 60). Use the DIMM-A0 slot to install the
first DIMM and DIMM-B0 slot to install the second DIMM.
Note: Approved DIMMs are available from your authorized service/support center.
To replace a DIMM
1 Access and open the E-36A (see page 50 ).
2 Remove the printer interface board from the motherboard (see page 57 ).
3 To release a DIMM, push outward on the levers on each side of the DIMM (see Figure 36 ).
Figure 36: Releasing a DIMM
1 Lever
2 DIMM
3 Slot notch
1
2
3
1