29
Installation and Service Guide: Color Controller E-36A
Installing Hardware
7
On the
Manual Configuration
screen, do the following:
•
In the
IP Address
field, enter an IPv4 address. Press
OK
.
•
In the
Subnet Mask
field, enter a subnet mask IP address. Press
OK
.
•
In the
Default gateway
field, enter a default gateway IP address. Press
OK
.
•
When done, press
Save
. Press
Go Back
.
8
On the
Setup
screen, press
Exit Setup
.
9
Press
Reboot Now
.
Change the language of the E-36A
If necessary, you can change the default language of the E-36A set at the factory.
To change the E-36A language from Configure
1
2
In Configure, click
Fiery Server
>
Regional Settings
,
3
In the Server Language drop-down list, select a language.
4
Click
Save
.
5
Click
Continue
, then click
Reboot
.
Wait until the E-36A reboots and becomes Idle. It may take up to 15 minutes to complete the system language change.
To change the E-36A language from Fiery QuickTouch
1
On the Fiery QuickTouch screen, press the
Quick launch
icon on the bottom-left corner (see
2
Log in to the E-36A as Administrator.
Note:
The default password will be set after any of the following:
•
You re-install the system software
•
You restore the recovery partition (from Fiery System Restore)
3
In the
Language
drop-down list, select a language.
4
Save the settings and then reboot the E-36A.
Wait until the E-36A reboots and becomes Idle. It may take up to 15 minutes to complete the system language change.