
56
Installation and Service Guide: Color Controller E-36A
Replacing Parts
3
Connect the USB cable and tie it to the support bracket using a tie wrap.
4
Connect the power cable.
Loop the cables around the guides available inside the chassis walls.
5
Insert the screw which holds the metal connector to the Fiery QuickTouch and tight it to secure the Fiery
QuickTouch.
6
Insert the front screw and tight it to secure the front portion of the Fiery QuickTouch
7
Insert the two rear screws and tight them to secure the rear portion of the Fiery QuickTouch.
8
Replace the front panel (see
).
9
Replace the chassis panel (see
10
If you replaced the Fiery QuickTouch with a new one, install the Fiery QuickTouch software (see
Removing and replacing
E-36A internal components
Before replacing costly components, be sure to verify the connections between the printer and the E-36A. Also, verify
the connections of each replaceable E-36A component. For more information about troubleshooting, see
The following sections describe how to remove and install replaceable parts on the E-36A:
•
Printer interface board
•
Motherboard
•
DIMM
•
CPU and CPU cooling assembly
•
Battery
•
Chassis fan
•
Power supply
•
Hard disk drive (HDD)
Use a screwdriver with a magnetic tip so you do not drop a loose screw into the E-36A.