EFI E-36A, Installation And Service Manual, Page: 102 / 129

102 Installation and Service Guide: Color Controller E-36A
Installing System Software
6 Start the E-36A (see page 42 ).
Allow the E-36A to start.
7 When the language selection screen displays, select a language.
8 When “What do you want to do?” screen displays, select Restore using a backup image, or the recovery partition .
9 When “Select backup source” screen displays, select Restore from recovery partition.
10 When “All data on hard disk drive(s) will be erased. Continue?” message displays, select Continue to install the
system software.
Installing the Fiery QuickTouch software
Install the Fiery QuickTouch software when you encounter the following:
•
The Fiery QuickTouch is not responding.
•
You replaced the Fiery QuickTouch with a new one.
Before you install the Fiery QuickTouch software
If the Fiery QuickTouch does not start up after starting the E-36A, or if it is not responding, do the following before
you reinstall the Fiery QuickTouch software:
•
Restart the E-36A (see page 42 ).
•
Reboot the E-36A (see page 42 ).
•
Shut down the E-36A, wait one minute, and then power on the E-36A by pressing the power button on the front
panel (see page 42 ).
•
Reset the Fiery QuickTouch: press the reset button on the Fiery QuickTouch through the pinhole, and hold the
button down for two seconds (see Figure 47 ).
After performing these methods, if the Fiery QuickTouch does not start up or not responding, proceed to reinstall the
Fiery QuickTouch software (see page 102 ).
To install the Fiery QuickTouch software
1 Make sure that the E-36A is Idle.
2 From the monitor connected to the E-36A, or from the Remote Desktop Connection session or printer operation
panel, locate the folder that includes the system update image file using the following steps:
a Browse “C:\Glance\image\NX- <version_number> -system_update” folder. The image file is located in this folder
if the Fiery QuickTouch software installation was incomplete, or if the image file is downloaded but not yet
installed.
b If you do not find the above folder, go to the “C:\Glance\image_backup” folder. Copy “NX- <version_number> -
system_update” folder and paste it in “C:\Glance\image”.