75
Installation and Service Guide: Color Controller E-36A
Replacing Parts
Table 3:
Jumper pins on the motherboard
Chassis fan
A fan mounted inside the E-36A chassis draws air into the E-36A to cool components. The fan runs continuously when
the system is on. You should hear the fan start as soon as you power on the E-36A. If you do not hear the fan, there may
be a faulty power connection.
Use the following procedures to remove or replace the chassis fan.
To remove the chassis fan
1
Access and open the E-36A, (see
2
Disconnect the 4-pin fan cable connector from the FRONT FAN connector (J30) on motherboard.
3
Remove the four plastic rivets from the connector panel, while holding the fan assembly from the inside.
To remove a rivet, use a flathead screwdriver to pry loose the rivet head on the outside of the chassis while
squeezing and pushing the locked end of the rivet with your fingers or a pair of pliers. Set the rivets aside so that
you can replace them later.
Jumper
Description
J17
J17 is the Clear CMOS and Password jumper.
Default configuration: Jumper cap installed on pins 1 and 2.
Note:
Because the jumper cap is very small, it is not necessary—and could introduce an
error—to remove the jumper cap in order to clear the CMOS settings.
Pin 1