20
Chapter 2 Installing InterPBX Communication System
9. Restart
Go to Main Menu>Operation Management>Reboot. Press “Restart” to reboot
your computer.
You may change your computer IP setting to the original values after you finish
setting up the Blaze/Savanna Server. You will need to enter the new IP address
to connect to the Blaze/Savanna Server next time.
Connecting Blaze/Savanna Server via Console Port
When you forget the IP address of the Blaze/Savanna Server, you can connect a
computer to the console port of the Blaze/Savanna Server in order to check the
current IP address, gateway address, and subnet mask.
1. Connect one end of the RS232 transmission line to the computer’s COM
port and the other end to the Console port of Blaze/Savanna Server.
2. Open the Hyper Terminal program. Enter the connection name and set the
baud rate to 9600 bps.
3. Turn off the power of Blaze/Savanna Server. Wait for a while and then
turn on the power again. The computer can start to connect to the
Blaze/Savanna Server.
4. You can see the IP address from the “Hyper Terminal” page. You can also
change the IP address here. If you are going to change the IP address,
please press any key within 3 seconds to setup.
NOTE:
The RS-232 DB-9 connector enclosed with the package is with pin 2/3,
pin 4/6, and pin 7/8 shorted.
