Dionex AS-HV, Operator'S Manual

Page: 81 / 122

B • Installation
Doc. 065125-01 10/06
73
B.3.10 Connecting the AXP Pump (Optional)
The AXP pump with Ship Kit (P/N 064507) includes the following parts:
1. Place the AXP pump near the AS-HV on the lab bench.
2. To operate the pump as a standalone device, connect it directly to a
serial port on the Chromeleon PC, using the RS-232 cable
(P/N 060683) shipped with the AS-HV.
If a serial port is not available, use the optional RS-232-to-USB cable
(P/N 064261) to connect the pump to a USB port on the PC.
NOTE The driver provided with the RS-232-to-USB
cable must be installed on the PC before the
cable is attached to the USB port.
3. To control the pump through the AS-HV, connect the RS-232 cable
(P/N 060683) shipped with the AXP to the AUX port on the side panel
of the autosampler.
NOTE To support sample overlap (see “Sample
Overlap” on page 12 ), the AXP must be
connected to the
AUX
port.
4. Connect the liquid lines as required for either the push mode (see
Figure B-11 ) or the pull mode (see Figure B-12 ).
5. When you finish the plumbing connections, go on to Section B.3.14 .
Part Number Item Quantity
063978 AXP pump assembly 1
042806 1/4-28 x 10-32 coupler 1
043275 10-32 double-cone bolt 4
043276 Double-cone ferrule fitting 4
054410 PEEK tubing, 1.0-mm (0.040-in) ID 50.8 cm
(20 in)
044221 PEEK tubing, 0.13-mm (0.005-in) ID 50.8 cm
(20 in)
053891 Dionex Reference Library CD-ROM 1