Dionex AS-HV, Operator'S Manual

Page: 78 / 122

AS-HV Operator’s Manual
70
Doc. 065125-01 10/06
8. Locate one tube anchor along the X-axis cover, about 18 cm (7 in)
from the column case. Locate the second tube anchor toward the
back, about 11.4 cm (4.5 in) from the column case (see
Figure B-8 ).
9. Attach the tubing to the middle tube anchor (the anchor installed first)
using the two tube markers (see Figure B-8 ).
10. Route the tubing along the side of the X-axis arm. Anchor the tubing
in position, spacing the tube anchors so as to minimize the route to the
IC (or other analyzer). When you finish, adjust the length of the
sample line to the analyzer.
Figure B-8. Attaching the Tubing to the Middle Tube Anchor
Install this tube
anchor first
X-Axis Cover
Install this tube
anchor second