Dionex AS-HV, Operator'S Manual

Page: 50 / 122

AS-HV Operator’s Manual
42
Doc. 065125-01 10/06
4.3 Initialization Sequence Fails
If the AS-HV fails to complete the initialization sequence by driving the sampling
arm (see
Section 3.2.2 ), the following events occur:
•
The
ERROR
indicators on the AS-HV side panel display error code 0101 (see
Table C-1) .
•
The error is reported to Chromeleon and recorded in the Audit Trail.
Corrective action:
1. Turn off the AS-HV power.
2. Check each axis (see Figure 3-1 ) manually for correct travel to determine
whether there is any mechanical obstruction.
3. If you do not find any mechanical obstructions, turn on the AS-HV power. If
the autosampler again fails to initialize, contact Dionex for assistance.
To avoid injury, turn off the power to prevent the sampling arm from
inadvertently moving while you are manually checking each axis.
Afin d'éviter toute blessure par suite du déplacement inopiné du bras
robotique, couper l'alimentation secteur pendant le contrôle manuel
des axes.
Um Verletzungen zu vermeiden, schalten Sie das Gerät bitte immer
aus, während Sie die Achsen manuell überprüfen, damit sich der
Probenarm nicht unbeabsichtigt bewegt.