Dionex AS-HV, Operator'S Manual

Page: 70 / 122

AS-HV Operator’s Manual
62
Doc. 065125-01 10/06
B.3 Installing the AS-HV
B.3.1 Installing the Spill Tray
A spill tray (P/N 064251) is installed in the AS-HV at the factory. If the
spill tray becomes separated from the autosampler during shipping,
follow the procedure below to reinstall the tray.
1. Check that the alignment pins protrude above the base support tube
(see Figure B-1 ).
2. Position the spill tray so that the two alignment pins at the rear of the
base support tube fit into the slots in the spill tray.
3. Lower the spill tray until the front edge rests on the front of the base
support tube.
4. Verify that the spill tray is secured in place by trying to move it from
side to side; the tray should not move at all.
Figure B-1. Installing the Spill Tray
Base Support
Tube
Spill Tray
(P/N 064251)
Alignment
Pin
Alignment
Pin