Dionex AS-HV, Operator'S Manual

Page: 71 / 122

B • Installation
Doc. 065125-01 10/06
63
B.3.2 Installing the Rack Location Mat
A rack location mat (P/N 064250) is mounted on the spill tray at the
factory. If the rack location mat becomes separated from the AS-HV
during shipping, follow the procedure below to reinstall the mat.
1. Note the cutouts in the sides and the rear of the rack location mat (see
Figure B-2 ).
The cutouts are designed to slot
over the raised locating tabs that
are molded into the spill tray; this
ensures proper alignment.
2. Position the rack location mat
over the spill tray. Check that the
slot for the rinse reservoir is
located on the left side of the mat,
and then press the mat onto the
locating tabs.
3. Verify that the rack location mat
fits firmly in place by trying to
move it from side to side; the mat
should not move at all. If the mat
does not fit properly, contact
Dionex for assistance.
Figure B-2. Rack Location Mat
Cutouts
Cutouts
Cutouts
Cutouts