Cisco D9854, Installation And Configuration Manual, Page: 46 / 440

Chapter 2 Quick Setup - Read Me First!
22
Setting up the MOIP Outputs
The following displays the rear panel of the D9854 Base Model:
1 Press MENU to move to the Main Menu.
2 Press to move to the Setup menu. Press SELECT .
3 Press to move to the Outputs menu. Press SELECT .
4 Press to move to the TS Out menu. Press SELECT .
5 Press to move to the MOIP menu. Press SELECT . Press . Press SELECT for
Rate Control. Use to select User . Selecting Auto for Rate Control results in the
device setting the output rate to be the same as the input rate. Press SELECT .
Note: You can set the User Rate in Step 9.
6 Press to move to the Output Mode. Press SELECT . Use to choose the
output mode for your application. Press SELECT .
7 Press to move to Descrambling Mode menu. Press SELECT . Use to select
the scrambling mode. Press SELECT .
8 Press . Press to move to Insert Null Packet. Press SELECT . Use to change
the selection to No . Press SELECT .
9 Press to move to the MOIP Streams menu and press SELECT .
10 Move to the User Rate menu. Press SELECT and use the keypad to enter the
desired bit rate. Press SELECT to save changes.
11 Press two times. Press SELECT . Use to change the selection to UDP or RTP.
Press SELECT .
12 Press . Press SELECT . Enter the Destination Address using the keypad. Press
SELECT . Press to move to UDPPort . Press SELECT and enter the port number
using the keypad. Press SELECT to save the change. Press to move to SrcPort .
Press SELECT and enter the port number using the keypad. Press SELECT to
save the change. The default is zero, which allows the system to assign a port.
13 Press two times. Press two times to move to PCR@IP Start menu. Press
SELECT . Press to set value to No . Press SELECT to save the value.
14 Press MENU to exit the menu level and save the changes.