Cisco D9854, Installation And Configuration Manual, Page: 151 / 440

Setup Menu
127
Menu Item Description Parameters
Act Selects the action to perform on
the current program entry.
This setting controls the overall
DPM behavior of the PE and
will affect how the PID
mapping operates.
Pass, Map, or Drop. The default is
Pass.
Pass - Output channel is the same as
the input channel. The OutCh, and
PMT settings are ignored. All PID
map entries are ignored except for
entries that explicitly drop a service.
Map - The output channel is mapped
to the OutCh and PMT settings. Only
services which have entries in the PID
map are available on the output.
These services will appear in the PMT
even if the stream is not present.
Note: If the PE is mapped, it uses the
last valid input. The output map (for
example, output channel PMT) does
not change automatically if the input
or channel number is changed.
Drop - The current channel is not sent
to the output and its PMT is removed
from the output. The OutCh, PMT,
and PID map entries are ignored.
OutCh If mapping the current PE (Act
was set to Map), set the output
channel number for the current
program.
1 to 65535
PMT If mapping the current PE (Act
is set to Map), set the output
PID of the PMT.
2 to 8190
PID Press Select to view and
configure the PID map. The PID
map is used to map input
services to output PIDs. For
more information, see PID Map
Menu (on page 130).
–
Map Mode Select the DPM mapping mode
for the current output. Svc ID - The elementary PIDs are not
changed. Channels are remapped by
changing their PSI references. When
this mode is selected, PID mapping in
the PID Map menu is ignored.
Svc ID & PID - Channels and the
elementary service PIDs can be
mapped using the PID Map menu.