Cisco D9854, Installation And Configuration Manual, Page: 113 / 440

Setup Menu
89
Menu Item Description Parameters
Gateway Sets the Network Gateway Address
on the Network, used to expose the
receiver to a WAN.
The IP Address/Mask and Gateway
Address should be changed together,
i.e., as a group. The following table
shows the most commonly used
Subnet mask values to enter for a
chosen IP address mask, which will
depend on the size of your network.
Mask Subnet Mask
8 255.0.0.0
16 255.255.0.0
24 255.255.255.0
Phy Mode Set the speed and duplex type of the
interface. Select Auto for PHY to
negotiate speed and duplex with
other devices on the network, or
select 10 HD (half-duplex), 10 FD
(full-duplex), 100 HD, 100 FD, or 1000
FD to lock into a fixed mode.
Auto (default), 1000FD (full duplex),
100HD (half duplex), 10FD, 100FD, or
10HD
MAC Address Displays the MAC address of the
interface. It is set at the factory and is
a read-only value.
N/A
SNMP Read Only
Community String Sets the password to read data from a
device and to display diagnostics
traps/alarms.
This is used when communicating
with a device within an SNMP
environment.
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.
SNMP Read Write
Community String Sets the password to write data to a
device.
This is used when communicating
with a device within an SNMP
environment.
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.