Cisco D9854, Installation And Configuration Manual, Page: 153 / 440

Setup Menu
129
Menu Item Description Parameters
Service ID Select whether the receiver
should always generate PSI
tables for the Mapped PE even
if the selected input channel is
not available, or for only valid
service channels/IDs.
Valid Ch - Only transmits the PSI
tables for the mapped program if the
program exists on the input stream.
All Ch - Transmits the PSI tables for
the mapped program even if the
program does not exist in the input
stream.
All Ch is only valid if the PAT, NIT,
SDT and PMT are set to Regenerate.
PAT, CAT, PMT,
TSDT, NIT, NITO,
SDT, SDTO, BAT,
EIT, TDT, RST, TOT,
DIT, SIT, ECM,
EMM, DRT, CDT
Selects the tables which will be
passed, dropped, regenerated,
or passed with rate control
(PwRC) from the output. For
more information, see
PSI
Table Settings (on page 131).
Note: The table settings are
only available if you selected
Ctl by Table in the PSI Options
menu.
–
PE Resync: All,
Template, PIDs, Svcs Each PE output can be
synchronized to its input
according to one of four output
modes. For information on
synchronizing output services,
see
Synchronizing Output
Services (on page 134).
Note: The resynchronization
will not synchronize the inputs
if there is no valid input on the
PE or if the PE is set to channel
0.
Svcs - Map the input to the output
based on the services only.
PIDS - Map the input to the output
based on the PIDs only.
All - Map the input to the output
based on the PIDs and services
Template - Map the input to a fixed
template output.
PAT/PMT Offset This is a customer-specific
mode, only to be used if
directed by Cisco. For more
information, contact Cisco
customer support.
–
NIT Offset This is a customer-specific
mode, only to be used if
directed by Cisco. For more
information, contact Cisco
customer support.
–