Cisco D9854, Installation And Configuration Manual, Page: 121 / 440

Setup Menu
97
Menu Item Description Parameters
Act Conv The actual aspect ratio conversion the
receiver will perform based on what you
have selected. This is read-only.
Refer to Aspect Ratio Conversions (on
page 97) for the conversions performed by
the receiver based on your selection, and
the effect on the picture displayed by the
receiver in each case (without Auto AFD)
None, 16:9 L/B, 4:3 P/B, 14:9,
4:3 CCO, 16:9 SCALE
WSS Mode Select the Wide Screen Signaling output
mode. It is used to select how the receiver
affects PAL WSS when it is present in the
VBI line 23.
Auto:Create - Creates WSS to
output the correct aspect ratio
when performing aspect ratio
conversion.
Auto:Modify - If WSS is present
in the input stream, it is
modified to output the correct
aspect ratio when performing
aspect ratio conversion. If WSS
is not present in the input, no
WSS will be present in the
output.
Suppress - Removes WSS
output.
Passthrough - Passes WSS
unmodified as received by the
receiver.
The default is Auto.
WSS Status This indicates the current output value of
PAL WSS in VBI line 23. 4:3 F/F, 16:9 L/B CEN, 16:9
L/B TOP, >16:9 L/B, 14:9 L/B
CEN, 14:9 L/B TOP, 14:9 F/F
CEN, 16:9 F/F, or UNDEFINED
Note: F/F is full format, and
L/B is letter box.
Aspect Ratio Conv ersions
The following table displays the conversions performed by the receiver based on the
Act Conv selection: