Cisco D9854, Installation And Configuration Manual, Page: 271 / 440

Configuring Transport Stream Information
247
Stream Details Description
Bitrate (Mbps) This is the output bit rate of the transport stream, in Mbps.
Encapsulation Selects the transport protocol to use for the output stream (UDP or
RTP).
Destination IP Enter the unicast (valid host IP only) or multicast destination IP
address.
Destination UDP
Port This selects the destination port number (1 to 65534).
Note: If you selected RTP for Encapsulation , you must choose an
even destination port number.
2 To modify the stream information, click the radio button of a stream and click
Edit .
3 Make the necessary changes and click Save .
4 To configure advanced stream settings, click a radio button of a stream and click
Advanced .
The following table describes the advanced settings:
Advanced Settings Description
Traffic Class Sets the quality of service (0 to 255).
Time to Live (Max #hops) This sets the hop limit of the packet's lifespan (0 to 255).
Source UDP Port This sets the source UDP port number (0 to 65535).
Note: Set the Source UDP Port to 0 to use the default UDP
port (49162).
Announce Type
Choose RFC 2327 to send the Session Announcement
Protocol (SAP) messages according to the RFC 2327 standard.
Otherwise, choose
None to not send SAP messages.