Cisco D9854, Installation And Configuration Manual, Page: 259 / 440

Configuring Transport Stream Information
235
PSI Options Description
Pass All Transmits the incoming PSI Tables as is; does not modify the
content and rate. The SI Regeneration Option and table settings are
ignored.
Drop All Does not transmit any PSI Tables. The SI Regeneration Option and
table settings are ignored.
Ctl By Table
The operator can click Table Options to select the table specific
output mode for each table.
8 If Ctl By Table is selected as the PSI Table Output Option , click Table Options
to configure the DPM table options. The DPM Table Options (ASI) dialog box is
displayed.
Select the tables which will be passed, dropped, regenerated or passed with rate
control (PwRC) from the ASI Output. For more information on the table options,
see PSI Table Settings.
The CDT is different from the other tables listed because the CDT is referred to
within the PMT, rather than outside the PMT. Select Block CDT Output to
override the DPM PID map configuration for CDT PIDs and to always drop all
CDTs. Otherwise, clear the Block CDT Output to permit the output of CDTs
following the configured DPM PID map configuration and all other DPM
constraints.
9 From the PSI Regeneration Option drop-down list, choose whether to
regenerate the PSI tables to the output. You can select Always to regenerate all
the tables or As Needed to only regenerate the tables if the content has changed.
10 Click OK .