Cisco D9854, Installation And Configuration Manual, Page: 103 / 440

Setup Menu
79
Menu Item Description Parameters
LO1 (GHz) Sets the lower oscillator frequency, in GHz, of
the LNB. In a single band oscillator, set its
frequency, in GHz.
0.0 to 15.0 GHz. Must be
lower than the value for
LO2.
LO2 (GHz) Sets the higher oscillator frequency, in GHz, of
the LNB. In a single band oscillator, set this
value to 0.0.
0.0 to 15.0 GHz. Must be
higher than the value for
LO1.
Crossover (GHz) This is the crossover frequency, which is an
internal threshold frequency used for selecting
the LO1 or LO2 frequency, depending on the
current Downlink frequency settings. This
option is only used in dual-band LNB
applications.
0.0 to 15.0 GHz. In single-
band LNB applications, set
this value to 0.0.
Satellite This is the name of the satellite currently
selected. Choose the satellite you want to use
to receive the signal from the list of satellites
available. When you select a satellite, the
orbital position (OrbPos) is displayed. This is
important for automatic switching from one RF
input to another in the event of loss of the
signal, allowing the receiver to acquire an
alternate signal.
When the satellite is not
listed, enter the known
orbital position (OrbPos)
of the satellite you want to
use to receive the signal.
OrbPos This is the location in orbit of the satellite
currently being used. The satellite position (in
degrees) in combination with the direction
(either E (East) or W (West)) denotes the
satellite position the dish connected to the
current RF Input should point. This is used
when the satellite is not available in the look-
up menu list.
For manual configuration, simply enter the
location of the satellite using the numerical
keypad. The receiver will not recognize the
satellite name and identify it as Unknown. This
setting is required to resolve any ambiguity
between RF inputs during automatic disaster
recovery.
Degrees
E/W Denotes the satellite position the dish
connected to the current RF Input should
point. This is used when the satellite is not
available in the look-up menu list.
E, W or NA