Cisco D9854, Installation And Configuration Manual, Page: 201 / 440

Setting up Input Information
177
Parameter Description
Input Rate (Mbps) Displays the bit rate of the input transport stream, in Mbps.
Acquisition State Displays Full if the SI and PSI tables have all been found.
Otherwise, it will display Degraded if there are missing tables
or None if no SI or PSI tables have been found.
Link Status Displays the link status of the active data port (Up or Down).
Port In Use Displays the current input port in use (Data1 or Data2).
Transport Stream The Transport ID (in the range from 1 to 65535).
Locked Data1/Data2
Source When locked, this displays the source/host IP address of the
originator. If the signal is not locked, it will display N/A.
Switchover Reason Displays a description of the reason for the last redundancy
switchover (Setup, EthLinkStatus, TS Status, ProgStatus, or
None).
Switchover Date/Time Displays the last date and time for the last redundancy
switchover.
PCR Lock Indicates whether the system is locked to the required PCR PID
(Yes or No).
De-jitter Latency (msec) Displays the overall transport stream buffer latency, in
milliseconds.
FEC Bitrate (Mbps) Displays the input stream bit rate reported by the FEC decoder.
FEC CEC Indicates the current Corrected Error Count for the received
stream.
FEC PER Indicates the current Packet Error Rate of the received stream.