BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 73 / 426

Section 04 ENGINE
Subsection 04 (MAGNETO SYSTEM)
04-04-12
Ignition Timing
For ignition timing procedures of the 717 engine,
refer to IGNITION SYSTEM 08-02.
1, Magneto Housing Cover
Properly install O-ring no. 3 in magneto housing.
Apply Loctite 767 anti-seize on screws no. 2 , install
cover and wire support no. 17 . Torque screws no. 2
in a criss-cross sequence to 9 N•m (80 lbf• in ).
787 Engine
12, Stator
Install the stator in magneto housing cover no. 1
and torque screws no. 13 to 10 N•m (88 lbf• in ).
Replace wiring harness bracket no. 16 of stator
and torque screws to 4.5 N•m (40 lbf• in ).
1. Stator screws
2. Bracket
14, Trigger Coil
Install the trigger coil in magneto housing cover
no. 1 and torque screws no. 15 to 10 N•m (88 lbf• in ).
NOTE: The trigger coil is not adjustable.
1. Trigger coil
7, Magneto Housing
To install oil seal no. 10 of magneto housing, use
pusher (P/N 290 877 740) and handle (P/N 290
877 650).
1. Pusher
2. Handle
-
CAUTION
Never use any type of impact wrench at mag-
neto installation.
F06D0CA
2
1
F06D0DA
1
F01B2NA
1
2