BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 320 / 426

Section 10 STEERING SYSTEM
Subsection 02 (SPX MODEL)
10-02-3
1. Bolts
2. Steering stem arm
Remove support no. 11 and steering stem arm
no. 10 from steering stem.
NOTE: It is not necessary to remove steering ca-
ble from steering stem arm.
Pull out handlebar assembly.
Installation is essentially the reverse of removal
procedures. However, pay particular attention to
the following.
Lubricate with synthetic grease thrust ring no. 13
of rear support no. 14 and front support no. 15 .
REAR SUPPORT
1. Apply synthetic grease
2. Thrust ring shown removed for more clarity
FRONT SUPPORT
1. Apply synthetic grease
2. Thrust ring
NOTE: Make sure thrust rings are properly in-
stalled.
Install support no. 11 to steering stem arm
no. 10 .
NOTE: Insert lock nuts no. 17 in support no. 11 .
Screw only a few threads of the bolts no. 16 .
TYPICAL
1. Support
2. Steering stem arm
3. Insert lock nuts
4. Screw only a few threads of the bolts
Install handlebar assembly into rear support
no. 14 , taking care at the same time to insert
throttle cable and wiring harnesses.
-
CAUTION
While performing this procedure, take pre-
cautions to avoid damaging throttle cable
and wiring harnesses.
F01K17A
2
1
1
2
F01K0HA
F01K1FA
1
2
F01K09A
3
4
1
2