BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual, Page: 283 / 426

Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
09-02-19
INSTALLATION
28, Neoprene Seal
SPX, GSX Limited, XP Limited and
GTX Limited
If neoprene seal is damaged, replace it with a new
one.
TYPICAL
1. Neoprene seal
9, Jet Pump Housing
SPX Models
Apply Loctite Right Stuff around bailer and water
supply fittings.
1. Apply Loctite Right Stuff where indicated
GTS Model
Apply Loctite Right Stuff around bailer and water
supply fittings as well as around wear ring lip.
1. Apply Loctite Right Stuff where indicated
All Models
Generously apply synthetic grease on drive shaft
splines.
Make sure rubber damper is on drive shaft end.
Install jet pump. If necessary, wiggle jet pump to
engage drive shaft splines in impeller.
Apply Loctite 242 (blue) on stud threads of jet
pump housing.
Install flat washers no. 8 , lock washers no. 7 and
nuts no. 6 . Tighten nuts of jet pump housing in
a criss-cross sequence and torque to 33 N•m
(24 lbf•ft).
NOTE: Slightly lubricate wear ring with BOM-
BARDIER LUBE lubricant to minimize friction dur-
ing initial start.
F01J50A
1
F01J21A
1
-
CAUTION
Some watercraft require a shim between
hull and pump; if shim has been removed at
pump removal, be sure to reinstall it, other-
wise engine alignment will be altered.
F01J21B
1