BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual, Page: 321 / 426

Section 10 STEERING SYSTEM
Subsection 02 (SPX MODEL)
10-02-4
From bilge, route throttle cable and wiring har-
nesses into support
no. 11 and steering stem arm
no. 10 , and finally in front steering support
no. 15 .
1. Install handlebar assembly
2. Route throttle cable and wiring harnesses at the same time
Push handlebar assembly until steering stem
no. 9 is well seated into steering supports no. 14
and no. 15 .
1. Rear support (steering collar)
2. Front support
3. Steering stem
Position steering stem arm no. 10 and support
no. 11 onto steering stem.
Torque bolts of steering stem arm no. 10 to 6
N•m (53 lbf• in ).
1. Steering stem
2. Steering stem arm
3. Support
4. Torque to 6 N•m (53 lbf•
in )
5. Integrated flat key must be seated in keyway and steering stem
arm locked in place
NOTE: Once steering stem arm is properly tight-
ened, look between body and front support to
make sure there is no gap between steering stem
arm and its support. If there is a gap, components
are not properly installed.
Connect wiring harnesses.
Route throttle cable alongside bilge. Insert cable
barrel into carburetor throttle lever.
Insert throttle cable alongside choke cable in tie-
blocks.
For throttle cable adjustment, refer to CARBURE-
TOR 06-04.
-
CAUTION
While performing this procedure, take pre-
cautions to avoid damaging throttle cable
and wiring harnesses.
F01K0AA
1
2
F01K1BA
1
3
2
◆
WARNING
Make sure integrated flat key of steering
stem arm is properly seated in steering stem
keyway. Steering stem arm must be locked
in place before torquing the bolts.
F01K1NA
1
3
2
5
4