BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual, Page: 295 / 426

Section 09 PROPULSION SYSTEM
Subsection 03 (DRIVE SYSTEM)
09-03-11
ASSEMBLY
GSX Limited, XP Limited and GTX Limited
14, Seal Carrier
Properly support seal carrier housing no. 17 when
installing seals and bearing.
Install bearing no. 16 with the bearing/seal install-
er tool (P/N 295 000 107).
1. Press bearing in its housing
NOTE: Bearing can also be installed with the
same driver used at disassembly. Center bearing
in longitudinal axis of housing.
1. Push bearing centered in its housing
Install double-lip seal no. 15 with protector to-
ward jet pump.
On both seals no. 15 , raised edge of lip must be
located outwards of seal carrier.
1. Double-lip seal toward engine
2. Double-lip seal with protector toward jet pump
3. Raised edge of lip outwards
4. Seal carrier
Apply Loctite 518 all around seals outside diame-
ter.
Seals no. 15 can be carefully installed in housing
using bearing/seal installer tool (P/N 295 000 107).
Push seals until tool comes in contact with hous-
ing.
TYPICAL
Pack seals and bearing with synthetic grease (P/N
293 550 010).
-
CAUTION
Ensure to install stamped end of bearing
(showing identification markings) first on
tool. Never hammer the bearing into its
housing.
F01J51A
1
F01J2TA
1
F01J2FA
2
1
3
4
3
F01J1YA