BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual, Page: 99 / 426

Section 04 ENGINE
Subsection 05 (TOP END)
04-05-24
All Engines
To easily insert circlip into piston, use circlip in-
staller.
1. Circlip installer
– Remove sleeve from pusher then insert circlip
into its bore.
– Reinstall sleeve onto pusher and push until cir-
clip comes in end of tool.
TYPICAL
1. Circlip near end of tool
– Position end of tool against piston pin opening.
– Firmly hold piston against tool and tap tool with
a plastic tip hammer to insert circlip into its
groove.
9, Cylinder
717 and 787 Engines
To easily slide cylinder over piston, install on pis-
ton ring compressor (P/N 290 876 979).
1. Slide this edge
NOTE: Ring compressor will not fit on oversize
parts.
Make sure to align ring end gap with piston locat-
ing pin. Slide tool over rings.
ENGINE TOOL P/N
717 and 787 290 877 016
947 290 877 518
F06B01A
1
F00B0QA
1
-
CAUTION
The hand retaining the piston should absorb
the energy to protect the connecting rod.
F00B0RA
A01B1TA
1