BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 313 / 426

Section 09 PROPULSION SYSTEM
Subsection 05 (VARIABLE TRIM SYSTEM)
09-05-3
GENERAL
To test VTS control module, motor or switch, refer
to INSTRUMENTS AND ACCESSORIES 08-05.
REMOVAL
Disconnect ball joint no. 1 .
Remove clamps no. 2 .
Remove boot no. 3 .
To loosen nut no. 4 , use VTS socket tool (P/N 295
000 133).
Remove sealing washer no. 5 .
SPX Model
Remove the spacer no. 17 .
All Models
Disconnect wiring harnesses.
Pull out VTS assembly no. 6 from bilge.
DISASSEMBLY
7, Cover
Remove VTS cover by pressing on tabs.
1. Press tabs to remove cover
8, Motor
Disconnect wires of motor.
Remove retaining nuts no. 11 .
1. Remove nuts
2. Disconnect wires
Pull on motor to remove it.
9,10, Worm and Sliding Shaft
Simply pull on worm and sliding shaft in order to
remove them.
INSPECTION
3, Boot
Make sure boot is in good condition. If it is cracked
or teared, replace boot.
9, Worm
Inspect threads and splines of worm for wear. If
worm replacement is necessary, renew also slid-
ing shaft.
F01B2PA
VTS
F01J1WA
1
1
F01J1XA
1
2