BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 175 / 426

Section 06 FUEL SYSTEM
Subsection 02 (FUEL CIRCUIT)
06-02-10
GS, GSX Limited, GTI and GTX Limited
Disconnect fuel lines from baffle pick up and loos-
en lower clamp
no. 10 .
TYPICAL
1. Disconnect fuel hoses
2. Loosen lower clamp
Disconnect wiring harness of fuel sender.
Remove baffle from fuel tank.
All Models
Remove upper clamp no. 12 from adapter no. 11
and slide adapter from baffle.
Push inward on the 3 clips at the base of the baf-
fle in order to remove the filter. Pry base off using
a small slotted screwdriver (if necessary).
INSPECTION
1, Fuel Filter
Inspect fuel filter condition. Carefully use low
pressure compressed air to clean fuel filter. Re-
place filter if permanently clogged or damaged.
2, Fuel Filter Bowl
Check filter bowl for water contamination.
3, Gasket
Inspect gasket condition. Make sure gasket is
well positioned into the filter bowl
no. 2 .
1. Gasket in bowl
5, Fuel Filler Hose
Verify fuel filler hose for damage. Always ensure
that clamps
no. 4 are well positioned and tight-
ened. Torque clamps to 4 N•m (35 lbf• in ).
6, Pressure Relief Valve
This valve will eliminate fuel spillage when the
watercraft is upside down. If pressure is built up
in fuel system the valve should open at 10 kPa
(1.5 PSI) to release the pressure.
NOTE: It is a one-way valve with an arrow to indi-
cate the air flow.
7, Check Valve
Black side of the one-way check valve is the valve
outlet. It allows air to get in reservoir.
F02F1OA
1
2
◆
WARNING
Ensure that there is no leakage from the fuel
filter.
◆
WARNING
If pressure relief valve is stuck, the pressure
in fuel system will build up and it may cause
fuel leakage in engine compartment.
F01F02A
1