Section 02
MAINTENANCE
Subsection 04
(WATER-FLOODED ENGINE)
02-04-3
1. Drain plug
Drain completely the crankcase oil of the counter-
balance shaft. Reinstall drain plug with Loctite
515.
Add 30 mL (1 oz) of SAE 30 motor oil.
Reinstall filler plug.
947 Engine
Siphon the oil and add 40 mL (1.35 oz) of SAE 30
motor oil.
Reinstall filler plug.
All Models
Turn fuel valve to ON position.
Start engine; It may be necessary to use the
choke. If engine does not start, repeat previous
steps as necessary.
NOTE:
If engine does not start after several at-
tempts, check ignition system for spark occur-
rence. Refer to IGNITION SYSTEM 08-02.
Check crankshaft if needed, it may be misaligned
or deflected. Refer to BOTTOM END 04-06.
After engine has started, spray BOMBARDIER
LUBE lubricant through air intake silencer while
engine is running.
717 AND 787 ENGINES
1. Air intake silencer
2. Pull plug
3. Spray BOMBARDIER LUBE here
947 ENGINE
1. Air intake silencer
2. Spray BOMBARDIER LUBE here
Run engine until it reaches its normal operating
temperature.
-
CAUTION
To avoid starting motor overheating, the
cranking period should not exceed 5-10 sec-
onds and a rest period of 30 seconds should
be observed between cranking cycles.
F07D07A
1
-
CAUTION
Engine must be cooled using the flush kit.
F01F25A
1
2
3
F06F0CA
1
2
Summary of Contents for SEA-DOO GS 5626 1998
