BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 279 / 426

Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
09-02-15
25, Thrust Washer
Position jet pump housing no. 9 with the stator
vanes on top.
Insert thrust washer no. 25 in the stator seat.
1. Thrust washer properly installed in stator seat
26, Thrust Bearing
Apply Sea-Doo jet pump synthetic oil (P/N 293
600 011) on both sides of thrust bearing.
Position thrust bearing no. 26 on thrust washer
no. 25 .
1. Thrust bearing on top of thrust washer
24, Impeller Shaft
To prevent seal lip damage when inserting impel-
ler shaft, use impeller shaft guide (P/N 295 000
002).
Insert tool onto shaft end then carefully install
shaft in jet pump housing.
1. Impeller shaft
2. Impeller shaft guide
NOTE: If jet pump housing rest against a table,
raise it slightly to allow complete shaft insertion
with the shaft guide.
Remove shaft guide.
20, Impeller
Apply Loctite primer N (P/N 293 600 012) on
threads of impeller shaft
no. 24 . Allow to dry for 2
minutes.
NOTE: Loctite primer is used to reduce Loctite
271 curing time and to activate stainless steel and
aluminum surfaces for better bonding action. If
applied, complete curing time is 6 hours, if primer
is not used, allow 24 hours for curing time.
F00J0DA
1
F00J0EA
1
F01J1OA
F00J0FA
1 2