BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 248 / 426

Section 08 ELECTRICAL SYSTEM
Subsection 04 (STARTING SYSTEM)
08-04-11
Step : Retaining brush holder with a screwdriver
Step : Align here
Align end frame notch with brush holder notch/
yoke protrusion.
947 Engine
Install new O-rings and gaskets.
Insert thrust washer no. 7 onto armature shaft
with the non-metallic surface facing the end cover.
1. Non-metallic surface on this side
Install the 3 washers no. 8 and no. 9 onto arma-
ture shaft, with the thicker one in the middle.
1. Thick washer in the middle
When installing end covers no. 3 and no. 6 to
yoke, align index marks.
Apply Loctite 271 (red) on through bolts no. 5 and
torque to 6 N•m (53 lbf• in ).
STARTER INSTALLATION
Installation is essentially the reverse of removal
procedure. However, pay particular attention to
the following.
Make sure that starter and engine mating surfac-
es are free of debris. Serious trouble may arise if
starter is not properly aligned.
717 and 787 Engines
13,16, Screw
Apply Loctite 242 (blue) on threads and torque
starter screws to 22 N•m (16 lbf•ft).
17, Nut
Connect the RED positive cable to the starter and
torque nut to 6 N•m (53 lbf•
in ). Apply dielectric
grease on terminal and nut.
-
CAUTION
Make sure end frame fits perfectly on yoke.
F01H0UA
2
1
1
2
F06H1HA
1
F06H1NA
1