BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 181 / 426

Section 06 FUEL SYSTEM
Subsection 03 (AIR INTAKE)
06-03-4
Push the air intake silencer out of the carburetor
adapter
no. 3 .
Pull the air intake silencer rearward to remove it
from the lower bracket
no. 4 and remove it in a
rotating movement.
The air intake silencer is a molded piece and it can
not be opened. It has an integrated flame arrester.
ASSEMBLY
Assembly is essentially the reverse of removal
procedures. However pay particular attention to
the following.
SPX, GS, GTS and GTI Models
7, Flame Arrester Base
Apply Loctite 518 on mating surfaces of flame ar-
rester base.
Apply Loctite 242 (blue) on screws no. 10 and
torque to 10 N•m (88 lbf• in ).
5, Flame Arrester
Inspect condition of flame arrester. Replace or
clean as necessary.
SPX Model
Position the flame arrester with its embossment
toward TOP.
9, Gasket
Inspect condition of gasket. Make sure to proper-
ly installed gasket.
GSX Limited, XP Limited and GTX Limited
1, Air Intake Silencer
Apply Super Lube grease (P/N 293 550 014) to
mating surface of air intake silencer.
Make sure the air intake silencer is retained by the
lower bracket
no. 4 .
-
CAUTION
Do not modify air intake system, otherwise
calibration will be affected.
◆
WARNING
Do not operate watercraft without flame ar-
rester.
F00F04A