BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual, Page: 245 / 426

Section 08 ELECTRICAL SYSTEM
Subsection 04 (STARTING SYSTEM)
08-04-8
Release brush wires of yoke from brush holder
no. 2 .
Remove brush holder no. 2 .
1. Remove brush holder
To remove brushes from yoke no. 1 , loosen nut
and remove washers.
1. Loosen nut and remove washers
Remove brushes.
To remove bearing and seal in end cover, release
tabs of retainer.
1. Retainer
CLEANING
Discard all O-rings.
Clean brushes and holders with a clean cloth
soaked in solvent. Brushes must be dried thor-
oughly with a clean cloth.
Blow brush holders clean using compressed air.
Remove dirt, oil or grease from commutator using
a clean cloth soaked in suitable solvent. Dry well
using a clean, dry cloth.
Clean engine ring gear teeth and drive unit
(clutch).
NOTE: Bushings or bearings must not be cleaned
with grease dissolving agents.
Immerse all metal components in cleaning solu-
tion. Dry using a clean, dry cloth.
F06H1KA
1
F06H1LA
1
-
CAUTION
Yoke ass’y and drive unit assembly must not
be immersed in cleaning solvent.
◆
WARNING
Always wear safety glasses when using
compressed air.
F06H1MA
1