BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 296 / 426

Section 09 PROPULSION SYSTEM
Subsection 03 (DRIVE SYSTEM)
09-03-12
INSTALLATION
Installation is essentially the reverse of removal
procedure. However, pay particular attention to
the following.
XP Limited
14, Seal Carrier of Mid Bearing
Properly index flanges no. 22 together.
Install seal carrier and hand tighten nuts no. 21 .
NOTE: Apply Loctite 242 (blue) on studs.
Align the seal carrier using the following tools:
– Support plate kit (P/N 529 035 506).
NOTE: Use plate (P/N 529 035 507) for the 155.6
mm (6-1/8 in) jet pump.
1. Plate (P/N 529 035 507)
2. Support (P/N 529 035 511)
– Alignment shaft (P/N 295 000 141).
1. Alignment shaft
– PTO flywheel adapter (P/N 295 000 157).
1. PTO flywheel adapter
Install support plate at rear of watercraft.
Install adapter on shaft.
Carefully slide shaft through support plate and
seal carrier. Insert adapter end into PTO flywheel.
TYPICAL
1. Alignment tool
2. Seal carrier
Torque seal carrier nuts no. 21 in a criss-cross se-
quence in 2 steps as per following illustration.
NOTE: It is very important to tighten nuts of seal
carrier in a criss-cross sequence to maintain its
alignment.
F00B0FA
1 2
F00B0GA
1
F00B05A
1
F05I08A
1 2