BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 400 / 426

Section 14 WIRING DIAGRAMS
Subsection 01 (WIRING DIAGRAMS)
14-01-1
WIRING DIAGRAMS 0
WIRE COLOR CODES
First color of a wire is the main color. Second color
is the tracer.
Example: YELLOW/BLACK is a YELLOW wire
with a BLACK tracer.
WIRE DIGIT CODES
All Models Except SPX and GTS
First number indicates in which connector the
wire is plugged in.
Second number indicates the position of the wire
in the connector.
The letter at the end of the number (if applicable)
indicates a common circuit in the MPEM printed
circuit with another wire bearing the same letter.
Example: 2-18 (g)
The first number indicates that the wire is posi-
tioned in the connector
no. 2 of the MPEM.
The second number indicates that the wire is po-
sitioned in the terminal
no. 18 .
The letter (g) indicates a common circuit with an-
other wire(s) bearing the same letter (g) in the cir-
cuit.
PACKARD CONNECTOR
To remove terminal from connector housing, use
Snap-on TT600-4 tool.
AMP PLUG CONNECTOR
All Models Except SPX and GTS
These connectors are found on the MPEM.
When servicing electrical system, special care
must be taken when working with AMP Plug Con-
nectors in order to prevent any malfunction of the
system.
Description
AMP PLUG CONNECTOR
1. Plug assembly
2. Cover assembly
3. Mating seal
4. Wedge lock
5. Header assembly
6. Seal plug
7. Power wire
8. Signal wire
9. Locking tab
◆
WARNING
Ensure all terminals are properly crimped on
wires and connector housings are properly
fastened.
F01B1JA
F00H0WB
1
2
3
4
5
6
7
8
9
9