Avaya programming and use, Installation And Use Manual, Page: 82 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Using Centralized Telephone Programming
3-8
Using Centralized Telephone Programming
3
Use Centralized Telephone Programming from extension 10 or 11 to program features or store
telephone numbers for individual extensions. All features that can be programmed at an extension
can also be programmed by using Centralized Telephone Programming. Most features also can be
programmed on a system telephone at the user’s extension, except for the following:
■
Automatic Line Selection, Line Ringing, and Call Screening (F25) always must be
programmed by using Centralized Telephone Programming.
■
If an extension has a single-line telephone, you must program all features for the extension by
using Centralized Telephone Programming.
■
If an extension has a non-display system telephone, you must use Centralized Telephone
Programming to program Extension Name Display for the extension.
During Centralized Telephone Programming, the display telephone at extension 10 or 11 takes on
the characteristics of the telephone being programmed, including any System Programming
settings and lines assigned to the telephone. See
“Using System Programming” on page 3-4 for
more information about System Programming and the use of overlays.
To program a telephone from extension 10 or 11, follow these steps:
1. Place the Programming Overlay over the dialpad of the system display telephone at extension
10 or 11.
2. Press
f00
. A display similar to the following appears:
PROGRAM EXTENSION 10
(If you are programming from extension 11, “11" displays instead of “10.”)
3. Press
s
. A display similar to the following appears:
10 Enter Extension Name
This display is for the Extension Name Display feature. Skip to Step 4.
4. Press
s
again. The display reads:
SYSTEM PROGRAM
5. Press
c
. A display similar to the following appears:
CENTRAL TELEPHONE PROG
Extension: