Auerswald COMpact 5000R, Advanced Information

Page: 953 / 1388

IP Switch Relay
COMpact 5000/R - Firmware V7.4A - Advanced Information V13 06/2019
- 953 -
Note: As a a pre-requisite, off control must be supported by the relay
(for some relays, e. g. the a/b Switching Modules, switching off cannot be
controlled).
Plages horaires
Specifies after how many seconds the PBX will switch off the relay.
Possible entries: 0 to 6000 (0 only for manual relays).
Note: The switching duration is used for relays with the operating
modes Light, Door opener, Alarm, PC relay and Manual relay.
Note: To enable the PBX to switch off the relay after the specified
switching duration, off control must be supported by the relay and be
switched on (for some relays, e. g. the a/b Switching Modules, switching
off cannot be controlled). Alternatively, the hold time of the relay can be
used.
Délai de rétention
If switching off is not to be controlled by the PBx (for some relays, e. g. the
a/b Switching Modules, switching off cannot be controlled), the hold time
of the relay can be used instead of the switching duration. This will only
make sense if the hold time of the relay is sufficiently long, for example for
a door opener.
The PBX needs to know how long the relay will be held in order to
signalise holding of the relay on the system phones (see the manual of the
device in question).
Requirements:
• Created relay