Auerswald COMpact 5000R, Advanced Information

Page: 36 / 1388

Action URL (HTTP Request)
COMpact 5000/R - Firmware V7.4A - Advanced Information V13 06/2019
- 36 -
Action URL (HTTP Request)
An Action URL is a function that can send requests via a link to a certain
device. The device that receives the Action URL subsequently performs
this request. The request and the IP address/URL of the Action URL
receiving device is entered directly into the Action URL.
Note: Currently, Action URLs in the PBX can only be sent if an alarm
was configured and is triggered. However, in this way, all requests can be
sent that the Action URL receiving device recognizes.
Note: A maximum of 32 Action URLs can be configured.
The sequence can be as follows:
• Alarm detection via a switch input or a call to the alarm phone number.
• The set alarm delay time is running (0-99 seconds).
• The first alarm call run starts with the call of the first alarm subscriber.
At the same time, the Action URL is sent (Alarm type start). If an alarm
subscriber acknowledges the alarm, the alarm will be ended. At the
same time, an Action URL is sent (Alarm type acknowlegded). If the
alarm is not acknowlegded, it ends after all alarm loops. At the same
time, an Action URL is send (Alarm type timeout).
Proceed as follows for configuration:
• Configuring Action URLs for a device.
- Using the Configuration Manager (page Périphériques > URL
d’action )
• Linking an Action URL with an alarm.