ashtech HDS800, Reference Manual

Page: 70 / 678

54
Using the Web Server
–
Access Point Login
: Enter the login of the mobile
communication provider.
–
Password
: Enter the password of the mobile
communication provider.
• Click on the
Configure
button.
• Now please follow all the steps described in section
General Parameters on page 48 and then proceed with the
steps below.
• Still on the
Rover Setup
page, in the
Network
pane, set the
following parameters:
–
Connection
: Choose “Modem Direct IP - Port E”. As a
result, new fields appear in this pane that you should
set as instructed below:
– The rover being a client, enter the information (
Connect
Now
,
Address
,
Port
,
Login
,
Password
) allowing it to
connect to the base (the server) from which it is
supposed to receive corrections. The login and
passwords are required only if the server demands
authentication (e.g. SpiderNet). In that case, the
message “$GPUID,<login>,<password> will be
generated automatically and sent to the server when
clicking on
Configure
.
Enable
Connect Now
to allow the receiver to establish
the connection right after you have clicked on
Configure
.
• At the bottom of the page, in the
Differential Port
pane,
select the
Automatic
option to let the receiver detect the
incoming differential stream automatically.
NOTE:
Automatic
is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver. You just have now to
define the output messages (see
Defining Output
Messages on page 63 ).