ashtech HDS800, Reference Manual

Page: 279 / 678

263
Set Command Library
Normally you don’t have to record debug data. However, the
Ashtech Technical Support may ask you to do so if a problem
occurs in your receiver and Technical Support needs to
analyze the resulting log file to fix the problem. The content
of this file can only be analyzed by Ashtech as it uses a
proprietary, undisclosed data format, which in addition is
subject to change without notice.
Command Format
Syntax
$PASHS,ATL,s1[,d2][,f3][,d4][*cc]
Parameters
Example
Enabling the ATL message:
$PASHS,ATL,ON*01
Comment
• If the memory selected through $PASHS,MEM is
unavailable, then “ACK” is returned in response to the
command enabling recording (ON or AUT), prompting you
to read the status of the debug data recording using the
$PASHQ,ATL command.
Relevant Query
Command
$PASHQ,ATL
Parameter Description Range Default
s1
Controls debug data recording:
• ON: Enables debug data recording
• OFF: Disables debug data recording
• AUT: Automatically starts debug data
recording every time the receiver is
turned on.
ON, OFF,
AUT
OFF
d2
Recorded data:
• 0: Only $ATL messages from GNSS
board to system board
• 1: Only those from system board to
GNSS board
• 2: All data exchanged between GNSS
board and system board
0-2 0
f3 Output interval, in seconds
0.05, 0.1,
0.2, 0.5, 1
1
d4 Configuration index 0-1 0
*cc Optional checksum *00-*FF