ashtech HDS800, Reference Manual

Page: 62 / 678

46
Using the Web Server
• Password: changeme
Local Settings for
the Receiver
Administrator & IT
Manager
You should inform your IT Manager of the following before he/
she can set up the connection:
• The HDS800 is not fitted –and cannot be fitted– with a
firewall. If a firewall is needed in your local network, it
should be installed on a device other than the HDS800.
• The Ethernet port and the DHCP mode are active by
default.
• TCP/IP port #80 is used by default in the receiver.
If however, the default settings have been changed in the
receiver, you may have to do the following:
• Turn on the Ethernet port.
Use the command below to power up the Ethernet port:
$PASHS,ETH,ON
When the port is on and connected, the Ethernet icon
appears in the lower-right corner of the receiver screen. By
default, the Ethernet port is on.
• Set the DHCP mode or assign a static IP address.
Use the command below:
$PASHS,ETH,PAR
The syntax of these two commands is fully described in the
Set Command Library Chapter.
Preliminary
Instructions for
Web Server Users
The following information should have been passed on to you:
• Receiver IP address or host name,
• Connection profile (login + password).
To make a connection with the receiver:
1. You should know for certain that the remote HDS800 has
properly been connected to the LAN via its Ethernet port.
Otherwise no connection will be possible.
2. Make sure your computer is also ready for a TCP/IP
connection.
3. Launch the web browser on your computer.
4. In the Address box of the web browser, type the IP address
or host name of the receiver:
http://<receiver_address>
then press the Enter key.