ashtech HDS800, Reference Manual

Page: 64 / 678

48
Using the Web Server
With this option enabled, the
Baseline Length
field
disappears.
• Click
Configure
to complete the receiver configuration
phase.
• Read the status bar at the top of the screen. You should
see the
Mode
parameter in the first column switch to
“Rover/Heading”.
• Click on
STATUS
, then on
Receiver Status and Settings
. The
third data group (Heading) shows all the results of the
heading measurements.
Steady-state operation is achieved when
Status
= “Fixed /
Operation”, and MRMS and BRMS values are as low as
possible.
This web page also provides heading and roll/pitch
measurements in graphic form.
Setting an RTK
Position Output for
Antenna #1
Refer to Setting a Rover on page 48 .
Setting a Rover
How to Start
• Open the Web Server’s
Configuration
tab. The first time you
click on this tab, the Web Server will ask you to log in as
the administrator. Only the receiver administrator is
authorized to access the
Configuration
tab.
You are allowed to change the destination of a receiver
(e.g. it is currently a base and you want to change it into
a rover). In this case, on opening the
Rover Setup
tab, the
Web Server will retain part of the base settings that could
be applied to the rover (e.g. antenna type, etc.).
• Whatever the way RTK corrections are delivered to the
receiver, you will always have to define a number of
general parameters pertaining to the rover function. These
parameters are usually defined first. However when the
internal modem is used, it is advisable to configure the
modem first.
• Programming output messages in a rover is addressed
separately (see
Defining Output Messages on page 63 ).
General
Parameters
• Click on the
Rover Setup
menu.
• Set the receiver parameters: