Amada ML-2350A-CE, Operation Manual, Page: 86 / 235

86
ML-2350A/2351A
1. Setting Welding Schedules
Setting the Output Status (STATUS Screen)
In the following, the method of setting the STATUS screen is explained. On this
screen, check the displayed control method and the set the branch shutter at
the output destination to OPEN. Set or reset the number of laser light outputs.
⇒
For details of setting items, refer to "Welding Schedule Setting Screen" on page 67.
Checking the Control Method
(1) Press the "STATUS" button to display the STATUS screen.
Control by Laser Controller (PANEL CONTROL)
When the laser is independently used or when the power supply of the PLC or
personal computer connected to the laser is OFF, control is exerted from the laser
controller and "PANEL CONTROL" is displayed in "CONTROL DEVICE."
Control by External Input Signal (EXTERNAL CONTROL)
Connect the main unit to the PLC or the like and turn ON pin No.23 (control switching)
of the EXT.I/O (1) connector. Then, the control method is switched over to the
control by external input/output signals (EXTERNAL CONTROL) and "EXTERNAL
CONTROL" is displayed in "CONTROL DEVICE."